I have an issue regarding the #Offset parameter.
Descriptions I have found says:
“#OFFSET:...; - The time in seconds at which beat 0 occurs in the music. This is specified as a floating point value. e.g. "2.34".”
In my objective opinion this means
#Offset = “time in seconds beat 1 in music”-(60seconds/ “BPM”) = beat 0 in music
But the above calculation dosen’t make my steps synch.
Instead when I use the following calculation it synchs:
#Offset = -(“time in seconds beat 1 in music”) …..e.g. a negativt timevalue
Wich is right? OR
Does this have anything to do with the #BPM parameter:
I always use #BPM: 0.000=”BPM”;